Suit Styles, Designs and
Fabric Colors
The style of suit you buy has a definite bearing on your warmth
and the thickness needed. Styles of wet suits include a one-piece
jumpsuit, two-piece farmer john (farmer jane for women),
long sleeve shorty, and short sleeve shorty.
|
 |
 |
Jumpsuit
This is a one-piece suit. It covers the torso and limbs. The
head, hands and feet are the only parts exposed. This suit
offers the greatest amount of protect from the elements
encountered while diving.
It is available in front or rear zipper
 |
|
 |
Farmer John / Jane This covers the torso and lower
body. the top resembles coveralls worn by farmers (hence the
name) and leaves the head, arms, and upper neck exposed, as
well as the arm pits, a primary heat loss area. A jacket or
shorty is usually worn over it, which can double the
insulation over the critical torso area.
A farmer John provides greater protection to the torso
than pants (see below) since it covers the entire torso.
One or both shoulder tabs will have velcro as the
fastener. Zippered versions are also available. |
|

|
Pants
These cover the lower body, ranging up past the waist to the
midriff region. They are worn with a jacket or shorty over
them. |
|

rear zippered Neptune model shown
|
Long Sleeve
Shorty A shorty leaves the legs exposed, as when
wearing shorts. A long sleeve shorty covers the torso and
arms, fully covering them.
It protects the main heat loss areas except for the head
and can be worn alone or over pants of a farmer john/jane. |
|

|
Short Sleeve
Shorty Similar to above with the exception of short
sleeves, a short sleeve shorty is a good choice for those
who need minimal thermal protection as it protects the torso
and core temperature. A good fit around the arms is
especially important as one of the primary heat loss areas
(the arm pits) is just inches / centimeters from the sleeve
opening and can allow the pumping of water in and out of the
suit if it does not fit well.
It can be worn alone or over a jumpsuit to provide
additional thermal protection. |
|

|
Beaver Tail
Jacket This style does not cover the legs at all. It
covers the arms and chest and comes down to about the hips.
A flap in the rear (the beaver tail) passes forward between
the legs and attaches to the inside bottom front of the
jacket. Two twist locks and grommets, one on either side of
the zipper, were once common fasteners. They have been
largely replaced by velcro tabs.
These are typically worn over pants or a farmer John. |
|

|
Short (Farmer) John
This suit is primarily used for above water sports or
over a jumpsuit for additional warmth. This suit worn alone
offers minimal thermal protection as it covers only the
torso and groin. The short john may be purchased with an
attached hood for cold water diving.
One or both shoulder tabs will have velcro as the
fastener. Zippered versions are also available.
|
|
|
|

|
Combination
Suit A jumpsuit and a short sleeve shorty or short
john combination offer more versatility. This combination
allows the diver to dive warm water in the jumpsuit and
colder water in combination with the short sleeve shorty or
short john. The short sleeve shorty or short john may also
be used alone for above water sports such as water skiing,
wave running and wind surfing.
The edge has been outlined in blue to show where the
shorty ends. |
Design
Men's Suits
|
Atlantis |
Neptune |
|
 
|

|
|
Accents on sleeves and collar, also
bust panel on women's' suits. Raglan sleeves, crotch gusset,
full edge finishing and knee-pads. Glued and blind stitched
suits are available in 2, 3, 5, and 7mm nylon two side. All
seams are double glued, assembled by hand and sewn using
blind stitches on the inside and outside of seams |
Available in 2mm or 3mm nylon two side.
Two or three color accents on sleeves, collar, slash on
torso and ankles, also bust panel on women's' suits. Raglan
sleeves, crotch gusset, full edge finishing and knee-pads. |
Women's Suits
|
Atlantis |
Neptune |
Riviera |
|
 |
 |
 |
|
|
|
our women's only design with a French
high V look and other feminine accents |
Some divers wear a 3 or 5mm short sleeve shorty over a 2 or 3mm
one piece jumpsuit, giving them the greatest protection in the torso
area, while affording a great deal of flexibility in the arms and
legs. You will probably want to wear a hood
as 60 percent of your heat loss in water is from your head and neck.
You can choose from a standard hood, a cold water hood ( a hood with
an extended bib), and a warm water hood, which cover the head but
not the neck. These are sometimes referred to as Snoopy hoods.
You can even get some suits, particularly jumpsuits, with the
hood attached for minimal water flow in the region of your neck.
Other options include vests, and hooded vests, which if thin enough,
may be worn underneath a wetsuit jacket. Consider a spine pad to
fill in that space along your spine to prevent cold water from
flowing down it.
There are other factors to be sure. However, these used in
conjunction with your knowledge of self and the
water temperature/suit thickness guide should enable you to pick
the right suit for yourself.
COLORS
We usually stock the following colors in the materials listed
below Please check for current availability in the thickness you
desire.
Actual colors may vary due to a number of factors, including your
graphics card and monitor settings. We will be adding photographic
images of actual material to give the best representation of color
possible.
Wetwear NCN (nitrogen composed neoprene)
Excellent for sport diving to depths of 130 feet
|
|
black |
royal blue |
purple |
neon yellow |
neon green |
|
Nylon two |
|
|
|
|
|
|
|
|
|
|
|
|
Rubatex G-231N nitrogen blown neoprene (the very finest
neoprene made)
Excellent for extremely deep diving to depths in excess of 400
feet
|